Rust remover "TANK CURE"
Tanks with a rusted inside can be treated very well with this product.
We recommend using the Rust Remover if the inside of your tank is seriously rusted.
"TANK CURE" products allow you to professionally overhaul the inside of your fuel tank.
"TANK CURE" is manufactured by POLY-SERVICE. This gasoline-resistant Tank Sealant is widely used
applied in the Netherlands, Germany, England and Belgium. Users have more than 15 years of very satisfactory experience
built with this kit. It has been successfully applied to steel, aluminum, polyester and carbon fiber tanks.
Treating the tank before applying Tank Sealant
To ensure good results you should always do some preparation to your tank.
Before applying the sealant, the tank must be absolutely dry, free of grease and virtually free of rust.
"TANK CURE" offers you products that will help you prepare the tank.
Tank cleaner "TANK CURE"
Rust remover "TANK CURE"
"TANK CURE" Epoxy Remover
These products form an ideal basis before applying our tank sealant. We briefly highlight each product:
Tank cleaner "TANK CURE"
This is a strong cleaning fluid to degrease your tank. We recommend always using this product because
this ensures good adhesion of the sealant to the surface of the patrol tank.
Especially if you apply the sealant in a tank for a two-stroke engine, it is necessary to use the tank cleaner first.
Rust remover "TANK CURE"
Tanks with a rusted inside can be treated very well with this product.
We recommend using the Rust Remover if the inside of your tank is seriously rusted.
"TANK CURE" Epoxy Remover
This product removes all old layers of paint and/or sealant. Only use this product if you want to apply a new sealant
or if you plan to do any welding on your tank. You only need this product if you want old layers of sealant or paint
remove or if welding is required on a tank with sealant on the inside.
For a motorcycle tank you need 1/2 liter of Tank Cleaner and 1/2 liter of Rust Remover.
What can you achieve with our Tank Sealant?
heal rusted tanks
stop leakage through seams and holes
preventive treatment against leaking seams, holes and rust formation
shielding contamination in oil tanks (after sandblasting)
Application of the tank sealant:
To ensure good results you should always do some preparation to your tank.
Before applying the sealant, the tank must be absolutely dry, free of grease and virtually free of rust.
It is highly recommended to use our TANK CURE Cleaner and TANK CURE Rust Remover
according to our usage guidelines to ensure good results. These products have been extensively tested
combination with our Tank Sealant.
"TANK CURE" tank kit is based on a 2-component epoxy resin. After joining the two components
stir well for a few minutes, empty the can into your gas tank and close the filler neck tightly.
Now slowly rotate the tank in all directions. Continue spinning for about 15 to 20 minutes. The sealant must cover all surfaces
hit several times to form a good layer. Now open the filler cap and turn the tank upside down to drain as much sealant as possible.
You will find several products on the market to treat gasoline tanks.
Whatever product you decide to use, it is very important to apply enough sealant to seal the inside of your
tank completely. Since you cannot see inside the tank during the sealing process, you need to be on the safe side.
Experience shows that for a petrol tank of 15 to 20 liters you need approximately 450 grams. “TANK CURE” delivers two
standard packages kit. A 450 gram package for motorcycle tanks up to 20 liters and a 600 gram package for car tanks up to 60 liters.
